冷门赚钱行业

全國服務熱線:15953195999
產品中心
您所在的位置:首頁-新聞中心-新聞動態-預防電動叉車電路線束燒毀的措施!

預防電動叉車電路線束燒毀的措施!

來源:http://nukkadh.com/冷门赚钱行业 日期:2019-12-24 發布人:admin

  電動叉車,顧名思義是由蓄電池為主導核心控制器的叉車!除此以外,為了賦予電動叉車有更多的功能,而實現這些功能,往往需要更多的線束來控制。那么,一旦電動叉車長時間工作或預見高溫天氣,預防電動叉車電路線束燒毀的措施,你就很有必要知道!

  Electric forklift, as the name implies, is a forklift with battery as the leading core controller! In addition, in order to give electric forklift more functions, and to achieve these functions, often need more harness to control. Then, once the electric forklift works for a long time or foresees the high temperature weather, it is necessary to know the measures to prevent the electric forklift circuit harness from burning!
  1、使用中經常發現有的電動叉車上的線路較亂,多余導線、外露線頭較多,隨意亂接電線的現象也比較普遍。由此導致全車線路混亂,常會引起人為電路故障,很難查找,嚴重時會發生搭鐵短路,燒毀電氣設備和線束,引起火災事故,直接影響到叉車的安全操作運行。
  1. In use, it is often found that the lines on some electric forklifts are disorderly, there are many redundant wires and exposed wires, and the phenomenon of randomly connecting wires is also common. As a result, the line of the whole vehicle is disordered, which often causes artificial circuit fault, which is difficult to find. In serious cases, there will be short circuit to ground, burning electrical equipment and wiring harness, causing fire accidents and directly affecting the safe operation of forklift.
  2、在維修叉車電路線束時,必須遵守修理規范,按照叉車低壓線路的線色、代號及編號布置的標準布線,絕不能在故障尚末排除時就另行接電源線,或某一線段損壞時,不管顏色,不論粗細,就隨意地換線,這樣會人為造成整車的電路線束混亂、故障增多的后果。更換熔絲前,應該關掉所有電氣設備及點火開關,并按規定進行更換。
  2. In the maintenance of forklift circuit harness, it is necessary to observe the repair specifications, follow the standard wiring arrangement of line color, code and number of low-voltage line of forklift, never connect the power line separately when the fault has not been eliminated, or change the line arbitrarily when a line section is damaged, no matter the color or thickness, which will cause the confusion of circuit harness of the whole vehicle and the consequence of more faults. Before replacing fuse, all electrical equipment and ignition switch shall be turned off and replaced as required.
濟南二手叉車
  3、若更換后的熔線又被燒斷,則說明系統有短路現象,應該仔細檢查并排除故障后再給予更換。有電源總開關的叉車,停車熄火后,應該關閉電源總開關。定期對線路總熔斷器進行檢查、養護和調整,必要時更換新的零配件。
  3. If the replaced fuse is burnt out again, it means that the system is short circuited, and it should be replaced after careful inspection and troubleshooting. For forklift trucks with main power switch, the main power switch shall be turned off after shutdown. Check, maintain and adjust the main fuse regularly, and replace new parts if necessary.
  電動叉車電路故障多半比較隱蔽,且多由導線引起,常見線路燒損多由叉車電源線短路搭鐵,其電源線路未使用短路過載保護裝置引起的。預付叉車電路線束燒毀的措施,你get到了嗎?
  Most of the circuit faults of electric forklift are hidden, and most of them are caused by wires. Most of the common circuit burns are caused by the short-circuit grounding of forklift power line, which is not caused by the use of short-circuit overload protection device. Did you get the measure of burning down the electric harness of prepaid forklift truck?

版權所有 ? 2018濟南韓工機械設備有限公司 All Rights Reserved
地址:山東省濟南市章丘區龍山街道辦事處東3公里路北韓工叉車濟南4S店   電話:15953195999
冷门赚钱行业 網站:http://nukkadh.com/   備案號:魯ICP備14018186號-1  技術支持:

 

【BENZHANTUPIANJUNYOUWANGZHANSUOYOUFANGTIGONG,BUFENTUPIANLAIYUANYUWANGLUO,RUWUYIZHONGQINFANLEMOUMEITIHUOGERENDEZHISHICHANQUAN,QINGLAIXINHUOLAIDIANGAOZHI,BENWANGZHANJIANGLIJISHANCHU。】

开心生肖 贵州11选5开奖结果 福建11选5走势图 广东11选5开奖结果 湖北11选5开奖结果 正规捕鱼游戏 正规捕鱼游戏 万丰国际赌场