冷门赚钱行业

全國服務熱線:15953195999
產品中心
您所在的位置:首頁-新聞中心-新聞動態-操作叉車時的注意事項和保養

操作叉車時的注意事項和保養

來源:http://nukkadh.com/ 日期:2020-05-20 發布人:hangong

開叉車的注意事項
Precautions for forklift operation
1、經培訓并持有駕駛執照的司機方可開車;
1. Drivers who have been trained and hold driving license can drive;
2、在開車前檢查各控制和警報裝置,如發現損壞或有缺陷時,應在修理后操作;
2. Check all control and alarm devices before start-up, and operate after repair in case of damage or defect;
3、搬運時不應超過規定負荷,貨叉須全部插入貨物下面,并使貨物均勻放在貨叉上,不許用單個貨叉尖挑貨物;
3. During handling, the load shall not exceed the specified load, and the fork shall be inserted under the goods completely, and the goods shall be evenly placed on the fork, and it is not allowed to pick up the goods with the tip of a single fork;
4、平穩地進行起動、轉向、行駛、制動和停止,在潮濕的或光滑的路面,轉向時須減速;
4. Start, turn, drive, brake and stop smoothly, and slow down when turning on wet or smooth road;
5、裝物行駛應把貨物放低,門架后傾;
5. When loading, the goods shall be lowered and the gantry shall be tilted backward;
6、坡道行駛應小心行駛,在大于十分之一的坡道是行駛時,上坡應向前行駛,下坡應后退行駛,上、下坡忌轉向,叉車在行駛時,請勿進行裝卸作業;
6. When driving on a ramp, drive carefully. When driving on a ramp larger than one tenth of the ramp, drive forward when uphill and backward when downhill. Do not turn when uphill or downhill. Do not load or unload when forklift is driving;
7、行駛時應注意行人、障礙物和坑洼路面,并注意叉車上方的空隙;
7. When driving, pay attention to pedestrians, obstacles and potholes, and pay attention to the gap above the forklift;
濟南叉車租賃
8、不準人站在貨叉上,車上不準載人;
8. No one is allowed to stand on the fork, and no one is allowed to carry on the vehicle;
9、不準人站在貨叉下,或在貨叉下行走;
9. No one is allowed to stand under or walk under the fork;
10、不準從司機座以外的位置上操縱車輛和屬具;
10. It is not allowed to operate vehicles and accessories from positions other than the driver's seat;
11、不要搬運未固定或松散堆垛的貨物,小心搬運尺寸較大的貨物;
11. Do not handle the unfixed or loosely stacked goods, and handle the larger goods carefully;
12、起升高度大于3米的高門架叉車應注意上方貨物掉下,必要時須采取防護措施;工作時應盡量使門架后傾,并在最小范圍內作前后傾;
12. For high gantry forklift with lifting height of more than 3m, pay attention to the falling of goods above, and take protective measures if necessary; when working, try to make the gantry tilt back, and tilt back and forth within the minimum range;
13、加燃油時,司機不要在車上,并使發動機熄火,在檢查電瓶或油箱液位時,不要點火;
13. When refueling, the driver should not be on the vehicle and turn off the engine. When checking the battery or oil tank level, do not ignite;
14、離車時,將貨叉下降著地,并將檔位手柄放在空檔位置,發動機熄火并斷開電源,將手制動拉好,在坡道停車時,還須用墊塊墊住車輪。
14. When leaving the vehicle, lower the fork to the ground, put the gear lever in the neutral position, turn off the engine and disconnect the power supply, pull the hand brake well, and block the wheels when parking on the ramp.
叉車的保養
Forklift maintenance
要使叉車工作正常可靠,發揮叉車潛在能力,要有經常維護措施。技術維護保養措施,一般為:
In order to make the forklift work normally and reliably, and give full play to the potential capacity of forklift, regular maintenance measures should be taken. Technical maintenance measures, generally:
1、日常維護,每班工作后。
1. Daily maintenance, after each shift.
2、一級技術保養,累計工作100小時后,一班工作制相當于2周。
2. After 100 hours of technical maintenance, one shift work system is equivalent to 2 weeks.
3、二級技術保養,累計工作500小時后,一班工作制相當于一個季度。
3. After 500 hours of secondary technical maintenance, one shift work system is equivalent to one quarter.
關于叉車的注意事項和保養就先給大家介紹到這了,想要了解更多請點擊濟南二手叉車官網http://nukkadh.com
The notes and maintenance of forklift are introduced here. For more information, please click Jinan second-hand forklift official website http://nukkadh.com 。

冷门赚钱行业

KAICHACHEDEZHUYISHIXIANG

Precautions for forklift operation

开心生肖 贵州11选5开奖结果 福建11选5走势图 广东11选5开奖结果 湖北11选5开奖结果 正规捕鱼游戏 正规捕鱼游戏 万丰国际赌场

版權所有 ? 2018濟南韓工機械設備有限公司 All Rights Reserved
地址:山東省濟南市章丘區龍山街道辦事處東3公里路北韓工叉車濟南4S店   電話:15953195999
網站:http://nukkadh.com/   備案號:  技術支持:

 

冷门赚钱行业【BENZHANTUPIANJUNYOUWANGZHANSUOYOUFANGTIGONG,BUFENTUPIANLAIYUANYUWANGLUO,RUWUYIZHONGQINFANLEMOUMEITIHUOGERENDEZHISHICHANQUAN,QINGLAIXINHUOLAIDIANGAOZHI,BENWANGZHANJIANGLIJISHANCHU。】

开心生肖 贵州11选5开奖结果 福建11选5走势图 广东11选5开奖结果 湖北11选5开奖结果 正规捕鱼游戏 正规捕鱼游戏 万丰国际赌场