冷门赚钱行业

全國服務熱線:15953195999
產品中心
您所在的位置:首頁-新聞中心-新聞動態-二手叉車怎么維修保養?

二手叉車怎么維修保養?

來源:http://nukkadh.com/ 日期:2018-10-29 發布人:admin

一、叉車剎車片

 
Forklift brake pad
 
叉車剎車片呈現磨損,在正常的叉車駕馭行車中,靠感覺是感覺不出來的。有些能夠直接查看,但有些車型需求拆卸出來才干看到。正常的剎車片有9毫米厚,當磨到2-3毫米時就必須換了;等全磨破顯露剎車片附著的金屬片,這樣就會呈現金屬與金屬沖突的異響。梯諾機械表明替換剎車片時一般修理工都是讓一切有相關的叉車配件都一同換掉,正常情況下都是能夠單換的,如:只是單剎車分泵漏油,換了剎車分泵后剎車片能夠清洗潔凈剎車片和剎車輪轂,假如是剎車片磨損的話剎車輪轂沒磨損,只換剎車片就能夠了,其他配件就清洗潔凈,軸承方位再從頭增加新的黃油即可,全部安裝好后再調 下剎車片和剎車輪轂之間的間隙就能夠正常運用了。
 
The forklift brake pad is worn out, and it can not feel out of the normal forklift driving. Some can directly view, but some models need to be disassembled to see. Normal brake pads are 9mm thick and must be replaced when worn to 2mm-3mm; when fully worn to expose the metal attached to the brake pads, there will be a metal-to-metal clash. Tino machinery shows that when replacing the brake pads, the general repairman is to replace all the relevant forklift parts together, under normal circumstances can be replaced singly, such as: only a single brake sub-pump leakage, replaced brake sub-pump after the brake pads can clean the brake pads and brake wheel hub, if the brake pads wear out the brake wheel The hub is not worn, just change the brake pad can be enough, other accessories on the clean, bearing bearing bearing position from scratch to add new butter can be installed after the adjustment of the brake pad and brake wheel hub clearance can be used properly.
濟南二手叉車
 
 
二、叉車火花塞
 
Two. Forklift spark plug
 
叉車火花塞是在修理時有許多的修理商都會勸叉車用戶提早替換的小配件,但實踐上假如駕馭員在用車時沒感覺到有焚燒不良、加速不力、沒有放炮等缺點現象的話就能夠不替換。可是定時要拆出來查看是有必要的,但假如火花塞確實壞了就一定要及時替換,有些車型壞了的火花塞還會呈現掉落掉在發動機的汽缸里邊,這樣就會引發更大的叉車缺點。
 
Forklift spark plug is a small part that many repairmen would advise forklift users to replace in advance when repairing, but in practice, if the driver did not feel burning, acceleration, no artillery and other shortcomings when using the truck can not be replaced. But it is necessary to take it out regularly, but if the spark plug does break, it must be replaced in time. Some models of broken spark plugs will fall into the engine cylinder, which will lead to greater forklift defects.
 
 
 
三、叉車剎車油
 
Three. Forklift brake oil
 
正常情況下修理工一般要求1年左右即進行替換,但實踐沒太大缺點,假如叉車制動體系配件未呈現異常就不必替換。但需常常查看有沒有短少或許蛻變或許也能夠經過目測,假如剎車油低于低液面就真的需求換或許直接增加了。叉車剎車油假如嚴峻短少會影響到剎車的制動功能,在替換叉車剎車油必須要換正品的,不是正品的用久了后會形成整套剎車體系會失靈。梯諾機械表明關于剎車油是否正品的檢測辦法能夠用以下這個辦法:伸個手指進到剎車油瓶內,泡到剎車油后然后伸出來在正常空氣中一分鐘左右手指有發熱的感覺,根本能夠判斷為這款叉車剎車油為正品。
 
Under normal circumstances, repairmen usually require about a year to replace, but the practice is not too big shortcomings, if the forklift brake system accessories did not show abnormal need not be replaced. But often check to see if there is a short or metamorphosed or can be visually monitored, if the brake oil is below the lowest level, the actual demand for replacement may increase directly. If the brake oil of forklift truck is severely short, it will affect the braking function of the forklift truck. The brake oil must be replaced by the genuine one, and the whole brake system will fail when the genuine one is not used for a long time. Tino Machinery shows that the test for brake oil can be used to determine whether the brake oil is genuine or not by stretching a finger into the brake oil bottle, soaking it in the brake oil, and then sticking it out in the normal air for about a minute or so. The brake oil can be judged to be genuine.
 
 
 
四、叉車機油
 
Four. Forklift oil
 
一些進口的機油正常情況下是在1500小時進行替換,而國產的機油一般是在750個小時左右就必須要替換。但實踐上只需油色明澈、油面不低于標明的低液面,沒有特別情況下機油的替換也不必那么頻頻。運用頻頻的叉車(一天操作超越十個小時以上)能夠一個月左右替換,運用需求一般的叉車(一天操作在正常的八小時內)能夠三個月左右保養一次,而運用較少的叉車(一天操作不超越三小時的)主張要半年保養一次,要不會形成發動機容易磨損和潤滑欠好的情況,機油必須挑選正品的來運用。
 
Some imported oils are normally replaced in 1500 hours, while domestic oils are usually replaced in about 750 hours. But in practice, only the oil color is clear, the oil level is not lower than the lowest level marked, there is no special case of oil replacement need not be so frequent. Frequent forklift trucks (operated more than ten hours a day) can be replaced about a month, with a general demand forklift truck (operated in normal eight hours a day) can be maintained about three months, while less forklift trucks (operated not more than three hours a day) advocate maintenance once a half year, or else The engine will wear easily and lubricate badly. The oil must be selected for proper use.
 
 
 
五、叉車液壓油
 
Five, forklift truck hydraulic oil
 
梯諾機械設備提示叉車的液壓油是不需求常常換,在正常情況下是3-5年左右再換一次,假如在運用中有漏油情況增加新的液壓油即可,液壓油要看在運用中的清潔度來決議是否替換,在挑選液壓油好是正品的,又是比較知名大品牌的即可。
 
Tino mechanical equipment prompts forklift hydraulic oil is not often replaced, in normal circumstances is about 3-5 years to change again, if there is leakage in the use of new hydraulic oil can be added, hydraulic oil depends on the cleanliness in use to decide whether to replace, in the selection of hydraulic oil is best genuine, but also more well-known Big brands can do that.
 
濟南二手叉車更多資訊點擊:http://nukkadh.com
 
More information on used forklift trucks in Ji'nan: http://nukkadh.com

版權所有 ? 2018濟南韓工機械設備有限公司 All Rights Reserved
地址:山東省濟南市章丘區龍山街道辦事處東3公里路北韓工叉車濟南4S店   電話:15953195999
冷门赚钱行业 網站:http://nukkadh.com/   備案號:魯ICP備14018186號-1  技術支持:

 

冷门赚钱行业【BENZHANTUPIANJUNYOUWANGZHANSUOYOUFANGTIGONG,BUFENTUPIANLAIYUANYUWANGLUO,RUWUYIZHONGQINFANLEMOUMEITIHUOGERENDEZHISHICHANQUAN,QINGLAIXINHUOLAIDIANGAOZHI,BENWANGZHANJIANGLIJISHANCHU。】

开心生肖 贵州11选5开奖结果 福建11选5走势图 广东11选5开奖结果 湖北11选5开奖结果 正规捕鱼游戏 正规捕鱼游戏 万丰国际赌场