冷门赚钱行业

全國服務熱線:15953195999
產品中心
您所在的位置:首頁-新聞中心-新聞動態-叉車起動機的組成介紹!

叉車起動機的組成介紹!

來源:http://nukkadh.com/冷门赚钱行业 日期:2019-02-20 發布人:admin

叉車啟動機主要是由以下幾大部分結合而組成

  Forklift starter is mainly composed of the following parts
  1、啟動機外殼, 殼是鐵制成的或者是鋁合金的,一般程圓筒狀,形成磁力線通路,內側面以永久磁鐵代替激磁線圈和鐵芯,以減小體積
  1. Starter housing, which is made of iron or aluminum alloy, is generally cylindrical, forming a magnetic line path, and permanent magnet is used to replace excitation coil and iron core on the inner side to reduce the volume.
  2、接觸器(磁吸開關)3、拔叉4、白金觸點5、連接接線頭6、接線柱7、螺絲8、螺母9、定子10、轉子11、碳刷架
  2. Contactor (magnetic suction switch) 3, fork pull 4, platinum contact 5, connection head 6, connection post 7, screw 8, nut 9, stator 10, rotor 11, carbon brush frame
  12、碳刷 正常是有四個,兩個是絕緣夾子支承;兩個接地,同樣用夾子支承并與整流子接觸。電流從碳刷經整流子通向電樞線圈,碳刷由彈簧壓在整流子上,并可在夾子 內上下滑動。電刷要求是單位面積通過的電流大,故會采用電阻小、電流容大的金屬石墨制作而成。
  12. Carbon brushes normally have four, two are insulated clamp support; two are grounded, the same clamp support and contact with the rectifier. Current from the carbon brush passes through the rectifier to the armature coil. The carbon brush is pressed on the rectifier by the spring and can slide up and down in the clamp. Brushes are made of metal graphite with small resistance and large current capacity because of the large current passing through the unit area.
濟南叉車租賃
  13、軸承,由于啟動負荷大、工作時間 短,故采用含油合金制造的滾珠軸承。軸承上有保證良好潤滑的油槽
  13. Bearing, because of its large starting load and short working time, is made of oil-containing alloy ball bearings. There is an oil groove on the bearing to ensure good lubrication.
  14、彈簧15、減速齒輪16、減速盤17、接觸齒輪(單向齒輪)18、O型密封圈19、鋼珠20、卡簧等等結構而組成。
  14, spring 15, deceleration gear 16, deceleration disc 17, contact gear (unidirectional gear) 18, O-ring 19, steel ball 20, clip spring and so on.
  叉車啟動機啟動時的工作結構路線:1.啟動電池的正極、2.電池連接頭、3.(粗)電纜線、4.啟動電機電磁閥白金觸點一端、5.(小)電源線、6.保險絲、7.電流表、8.點火鎖匙開關、9.啟動繼電器、10.啟動電機電磁閥線圈、11.白金觸點連接、12.啟動電機電纜線、13.啟動電機碳刷、14.轉子、15.搭鐵、16.電池負極。
  When starting forklift truck starter, working structure route: 1. positive pole of starter battery, 2. battery connection, 3. (thick) cable, 4. platinum contact end of starter motor solenoid valve, 5. (small) power line, 6. fuse, 7. ammeter, 8. ignition key switch, 9. starter relay, 10. solenoid valve coil of starter motor, 11. platinum contact connection, 12. starter motor cable, 13. carbon of starter motor Brush, 14. Rotor, 15. Tap iron, 16. Battery negative electrode.

版權所有 ? 2018濟南韓工機械設備有限公司 All Rights Reserved
地址:山東省濟南市章丘區龍山街道辦事處東3公里路北韓工叉車濟南4S店   電話:15953195999
冷门赚钱行业 網站:http://nukkadh.com/   備案號:魯ICP備14018186號-1  技術支持:

 

冷门赚钱行业【BENZHANTUPIANJUNYOUWANGZHANSUOYOUFANGTIGONG,BUFENTUPIANLAIYUANYUWANGLUO,RUWUYIZHONGQINFANLEMOUMEITIHUOGERENDEZHISHICHANQUAN,QINGLAIXINHUOLAIDIANGAOZHI,BENWANGZHANJIANGLIJISHANCHU。】

开心生肖 贵州11选5开奖结果 福建11选5走势图 广东11选5开奖结果 湖北11选5开奖结果 正规捕鱼游戏 正规捕鱼游戏 万丰国际赌场